Health and environment
Reza Hekmatshoar; Shahrzad Khoramnejadian; Ahmad Allahabadi; MohammadHossein Saghi
Volume 28, Issue 4 , September and October 2021, , Pages 533-544
Abstract
Introduction: Penicillin G (PG) is one of the most widely antibiotics used around the world. The release of PG in an aqueous solution leads to contamination of water resources. This study aimed to determine the efficiency of modified Eskanbil activated carbon for the removal of PG from aqueous solutions. ...
Read More
Introduction: Penicillin G (PG) is one of the most widely antibiotics used around the world. The release of PG in an aqueous solution leads to contamination of water resources. This study aimed to determine the efficiency of modified Eskanbil activated carbon for the removal of PG from aqueous solutions. The NH4Cl-induced activated carbon was synthesized by a simple method and used for the degradation of PG in contaminated water.
Materials and Methods: Activated carbon was characterized by Fourier transform infrared spectroscopy (FTIR), Field emission scanning electron microscopy (FESEM), and Brunauer–Emmett–Teller (BET) surface area analysis. The influence of important parameters including solution pH, contact time, and initial PG concentration, and dosage of adsorbent was examined on the efficiency of EAC in degradation of penicillin G in aqueous solution.
Results: The synthesized carbon was characterized. The BET results indicated that the surface area of the Activated Carbon catalyst was1473 m2/g. The maximum PG adsorption onto EAC was observed at the pH of 6. The PG removal of 33% at an EAC concentration of 0.1 g/L increased to 99.98% at an activated carbon concentration of 0.5 g/L. The isotherm and kinetic studies of PG removal by EAC showed that the Freundlich model (R2>0.995) and the pseudo-second-order (R2>0.983) equation represented the best fit with the adsorption data.
Conclusion: EAC is recommended as a suitable and cost-efficient adsorbent for removing poisons, pharmaceuticals, and other emerging contaminants from water resources.
Health and environment
Parisa Baratpour; Seyed Gholamreza Moussavi; Ahmad Alahabadi; Sakine Shekoohiyan
Volume 26, Issue 6 , March and April 2020, , Pages 797-807
Abstract
Background & Objective: With industrial development and population growth, the emerging contaminants enter into the natural water resources. Therefore, in this study Adsorption potential of NH4Cl-induced activated carbon (NAC) was investigated to remove antibiotic sulfanilamide from contaminated ...
Read More
Background & Objective: With industrial development and population growth, the emerging contaminants enter into the natural water resources. Therefore, in this study Adsorption potential of NH4Cl-induced activated carbon (NAC) was investigated to remove antibiotic sulfanilamide from contaminated water.Materials &Methods: The effect of operational conditions including solution pH, NAC concentration, sulfanilamide initial concentration and contact time were studied. Results: NAC and SAC had specific surface area of 1029, 1024 and mean pore volume of 2.64, 2.23nm, respectively. With increasing the NAC concentration to 1 g/L, sulfanilamide adsorption efficiency increased to 84.4% within 40 min. Then the adsorption slightly increased with the increase in the contact time to 120 min and reached to its maximum adsorption of 99.2%. The maximum adsorption percentage of sulfanilamide onto SAC under similar conditions reached to 49.2%. The kinetics analysis showed that experimental adsorption data for both NAC and SAC were best fitted to the pseudo-second-order model. The maximum adsorption capacity of sulfanilamide onto NAC and SAC, calculated by the Langmuir model, was 238.1 and 87/7 mg/g, respectively.Conclusion: Generally, these results showed that NAC was an efficient adsorbent with high removal efficiency for eliminating the antibiotics from the contaminated water streams
Mahnaz tora bi hokmabadi; Ahmad Allahabadi; Gholamreza Moussavi
Volume 26, Issue 3 , September and October 2019, , Pages 273-283
Abstract
Herbicides, including atrazine, are among the most important newly discovered contaminants found in water bodies and are hazardous to human health and the environment. adsorption is one of the best techniques used to remove these contaminants from contaminated water. Materials and method: In this ...
Read More
Herbicides, including atrazine, are among the most important newly discovered contaminants found in water bodies and are hazardous to human health and the environment. adsorption is one of the best techniques used to remove these contaminants from contaminated water. Materials and method: In this study, two carbon from waste Pomegranate and calligonum Comosum were used to remove atrazine herbicide. After chemical activation these carbons with NH4Cl, and then 800 ° C for 2 hours, parametric tests were performed and the effect of pH, adsorbent concentration, atrazine concentration and contact time were investigated; then absorption equilibrium tests; absorption capacity and its isotherms investigated for the removal of atrazine by two carbons were calculated. Results: The results showed that the carbon produced from the calligonum Comosum wood in optimal conditions at pH =7; carbon concentration 0.2 g/L, and the mixing time of 50 minutes could remove 100% atrazine at 25 mg/L . The carbon produced from pomegranate in optimal conditions pH =6; carbon concentration of 0.2 g/L and mixing time of 50 minutes could remove 91.5% atrazine to 25 mg/ L. Absorption equilibrium tests showed that the absorption capacity of carbon Calligonum Comosum and pomegranate were 672 and 645mg/g respectively. Discussion The results of this study showed that both carbons have high absorption capacity in the removal of atrazine herbicide and can be an effective and economical absorbent for the removal of this contaminant from natural waters.